关于f06文件读取的问题

又见非洲狮

*** USER FATAL MESSAGE 103 (SCA.MDSolver.Obj.InputFile.InputFile::read)
The input stream data file f:/ѧϰ/����/ha144a/ha144a.bdf must be a valid file name.
*** USER WARNING MESSAGE 209 (SCA.MDSolver.Io.AccessAccess.AccessAccess::isEchoSortRequested)
     No stream input file has been converted to its binary form using StreamToBinary.
The ECHO data returns will all be false.
*** SYSTEM FATAL MESSAGE 501 (SCA.MDSolver.Io.AccessAccess.AccessDatabase:pen)
     Error 1 occured while attempting to open database ./ha144a.IFPDAT.
*** SYSTEM FATAL MESSAGE 3001 (IFPDR)
     THE INPUT DATA BLOCK NAMED IFPFLAG  AT POSITION      1 DOES NOT EXIST.
     USER INFORMATION: THIS ERROR IS CAUSED BY ONE OF THE FOLLOWING:
          1. THE DATA BLOCK WAS NEVER CREATED.
          2. THE DATA BLOCK WAS DELETED.
          3. THE DATA BLOCK IS SPECIFIED ON A TYPE STATEMENT IN THE CURRENT SUBDMAP OR A HIGHER SUBDMAP
             BUT THE CURRENT QUALIFIER VALUES DO NOT MATCH
             THE QUALIFIER VALUES OF THE DATA BLOCK(S) ON THE DATABASE.
     USER ACTION: 1. IF YOU ARE EXECUTING AN MSC.SOFTWARE SUPPLIED SOLUTION SEQUENCE AND NOT USING THE
                     ALTER EXECUTIVE CONTROL STATEMENT, THEN CHECK FOR BULK DATA AND/OR CASE CONTROL INPUT
                     ERRORS. IF NO ERRORS CAN BE FOUND, THEN CONTACT MSC.SOFTWARE CLIENT SUPPORT.
                  2. IF YOU ARE EXECUTING A DMAP PROGRAM NOT SUPPLIED BY MSC.SOFTWARE, THEN FOR DEBUGGING PURPOSES
                     INSERT STATEMENT DIAGON(20) BEFORE THE MODULE SHOWN ABOVE.
     PROGRAMMER INFORMATION: THE FIST NUMBER IS    101 AND SUBROUTINE IS IFPDR
0FATAL ERROR
1                                        * * * END OF JOB * * *
哪位大神帮我看看，这是什么问题，我的好几个bdf文件用nastran求解后f06文件都显示这个

mxlzhenzhu

是不是模型文件下面不允许中文啊？你的目录换成全英文的试试。

又见非洲狮

mxlzhenzhu 发表于 2013-5-4 23:43
是不是模型文件下面不允许中文啊？你的目录换成全英文的试试。

我全是英文的啊，还有我想问一下啊，flight loads怎么用啊？

又见非洲狮

又见非洲狮 发表于 2013-5-5 07:52
我全是英文的啊，还有我想问一下啊，flight loads怎么用啊？

还是谢谢啊

wanghh291

*** USER FATAL MESSAGE 103 (SCA.MDSolver.Obj.InputFile.InputFile::read)
The input stream data file f:/ѧϰ/����/ha144a/ha144a.bdf must be a valid file name.

你的路径里有中文，文件夹必须是英文名

panp00

很怪异的 就是中文的路径 你再自信看看