- 积分
- 18
- 注册时间
- 2010-4-25
- 仿真币
-
- 最后登录
- 1970-1-1
|
1 Introduction
LSPP is a very small but effecient Prepost software for LS-DYNA. It supports 99.9% keywords of LS-DYNA and it is for free, for free!
"xiaminzn" have a question: How to make the force-disp curve by XY-plot in LSPP ?
This is a simple test and demonstration to show.
2 Model
i'm lazy to borrow the model which is performed at "How to set up the material failure for beam element?".
The cantilever beam subjected to uniaxial tension.
3 Results and xyplot
NOW, you wlill get the keypoint!
1) plot the axial force by Elout in ASCII
2) plot the node Z-disp by History, Where click "New" instead of "plot" to get a new window.
3) xyplot-->window-->cross, x-axis: disp(window#2:1), y-axis:axial force(window#1:1), then click "NEW"
the final is shown:
it's OVER!
P.S. Time is short, so the content above is very simple, and if you've found any mistake, don't hesitate to tell me.
Thank you very much.
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?注册
×
|