abaqus流固耦合做渗流分析时发出警告如下：

qinpei

3192 elements are distorted. Either the isoparametric angles are out of the suggested limits or the triangular or tetrahedral quality measure is bad. The elements have been identified in element set WarnElemDistorted.

There is zero VOL. FLUX everywhere in the model based on the default criterion. please check the value of the average VOL. FLUX during the current iteration to verify that the VOL. FLUX is small enough to be treated as zero. if not, please use the solution controls to reset the criterion for zero VOL. FLUX.

虽然有警告，但是还在算。。
大神们，这种问题可以忽略么？或者有什么解决办法呢？

萌新无

兄弟，我也遇到你的第二个警告了，请问是什么原因呢

cao123456

第二个警告可以忽略，不影响计算收敛的