钢结构中的梁柱铰接该怎么建模?

signalat2

thanx a lot

michael02

在Interaction module中用Coupling constraints.
详细见ABAQUS/CAE User's Manual，
Part IV: Creating and analyzing a model using the ABAQUS/CAE modules
19.14.4 Defining coupling constraints

BTW：希望版主能加一分，还差一分才可以上simwe的ftp啊！谢谢啦！

superzxd

俺觉得应该先在该处建立两个节点吧,每个节点分别连一个单元,然后将这两个节点耦合三个平动约束即可.

BTW：希望版主能加四分，还差四分才可以上simwe的ftp啊！谢谢啦！哇哈哈哈

ilovenili

michael02 wrote:
在Interaction module中用Coupling constraints.
详细见ABAQUS/CAE User's Manual，
Part IV: Creating and analyzing a model using the ABAQUS/CAE modules
19.14.4 Defining coupling constraints

BTW：希望版主能加一分，还差一分才可以上simwe的ftp啊！谢谢啦！

希望以后多多支持本版的工作！！

zftj

1: Use the *RELEASE option to release a rotational degree of freedom or a combination of rotational degrees of freedom at one or both ends of a beam or pipe element.

2: MPC type PIN provides a pinned joint between two nodes. This MPC makes the global displacements equal but leaves the rotations, if they exist, independent of each other