找回密码
 注册
Simdroid-非首页
查看: 200|回复: 4

'fluid_valve.fl' 中的问题

[复制链接]
发表于 2005-9-14 17:14:57 | 显示全部楼层 |阅读模式 来自 上海
在'fluid_valve.fl' 例子中,为什么边界 5,6(就是阀门的底边界)设定了y方向的速度? 我试过将该y方向上的速度改为零,运行后的结果我个人主观上觉得和原来一致。所以,不清楚例子的创建者真实物理意图。

另外,我们知道FEMLAB中的单位都是采用的国际标准制单位,所以水的密度应该为1000(kg/m3),可是在流体例子中的一个关于流体绕过圆柱的例子中,水的密度设定为1,而不是1000,所以不清楚是作者的疏忽,还是软件默认采用了乘以1000?

谢谢!
发表于 2005-9-14 19:06:22 | 显示全部楼层 来自 上海大学

Re:'fluid_valve.fl' 中的问题

Simdroid开发平台
这个问题,我个人认为这个例子还是不错的。希望和老兄深入交流!

Depiction of the geometry and the operation of the fluid valve. Flow enters from one inlet at the left, but can leave the valve through two outlets at the right. The choice of outlet depends upon the position of the valve pin. In this model, two valve pins oscillate from in front of one outlet channel to being in front of the other. Sometimes flow is possible through both outlets, depending on the position of the pins.
Wintersummer 该用户已被删除
发表于 2005-9-15 09:12:30 | 显示全部楼层 来自 黑龙江哈尔滨
提示: 作者被禁止或删除 内容自动屏蔽
 楼主| 发表于 2005-9-20 20:26:06 | 显示全部楼层 来自 上海

Re:'fluid_valve.fl' 中的问题

Thanks for the manager's reply!

   Since I am a beginner , I will learn and work hard about the software.

  As for the second question(the units), can anyone help me ?

  Looking forward !!!
y_yuehua 该用户已被删除
发表于 2005-9-29 16:03:41 | 显示全部楼层 来自 黑龙江哈尔滨
提示: 作者被禁止或删除 内容自动屏蔽
您需要登录后才可以回帖 登录 | 注册

本版积分规则

Archiver|小黑屋|联系我们|仿真互动网 ( 京ICP备15048925号-7 )

GMT+8, 2024-3-29 21:24 , Processed in 0.042207 second(s), 15 queries , Gzip On, MemCache On.

Powered by Discuz! X3.5 Licensed

© 2001-2024 Discuz! Team.

快速回复 返回顶部 返回列表