project网格
project面网格的时候,怎么会出现上图的情况?红色为源网格,蓝色为project过去之后的网格,中间为什么会有连接的网格?
网格project之前需要复制,否则投影的是原先的网格 cumtchendejin 发表于 2013-4-17 16:02 static/image/common/back.gif
网格project之前需要复制,否则投影的是原先的网格
我复制了,这个问题现在解决了,就是改变一下被投影面的位置,但是不知道是什么原因 the section of the red elements most probably slightly bigger than the cylindrical geometry you are projecting to. some nodes are out of the target surface.
in your case, since the target surface is on the same plane, so, you could project to plane rather than project to surface. 楼上正解
页:
[1]