蜗轮蜗杆瞬态动力学分析时报错
本帖最后由 madge3097 于 2016-10-21 08:17 编辑如题，我用的WORKBENCH14.5分析的，步骤和书上以及网络上的教程都一样的但是还是报错，下面是报错信息
;第一条是The solver engine was unable to converge on a solution of a nonlinear problem as constrained.
第二条是：The solution failed to solve completely at all time points. Restart points are avilable to continue the analysis.
第三条是：The uncoveraged solution(identified as substep 999999) is output for analysis debug purposes. Results at this time should not be used for any other purpose.
第四条是Although the solution failed to solve completely at all time points, partial results at some points have been able to be solved. Refer to Troubleshooting in the Help System for more details.
求大神指点
楼主你的问题解决了么 仿真科技论坛wt 发表于 2016-10-21 20:02
楼主你的问题解决了么
没有，你也是做这方面的吗，有好的方法要分享哦 仿真科技论坛wt 发表于 2016-10-21 20:02
楼主你的问题解决了么
没有 你也是做这方面的吗 同一个问题，不知道如何解决，跪求大神来帮忙
页:
[1]