请教OPTISTRUCT不能求解的问题
我在运行OPTISTRUCT求解时总显示如下的致命错误信息:ERROR # 7007 FROM SUBROUTINE check_memThe run failed because automatic memory expansion has failed.
Currently allocated working storage is 1292 MB.
Automatic expansion failed to expand to 1688 MB.
More than the failed amount of memory is required to complete the run.
Please verify whether the system has enough memory.If it has, then please
try this run with the fixed memory allocation to avoid a probable limitation
on the maximum locatable memory with the automatic memory allocation.
不知道这个固定内存分配在那改啊?
多谢! analysis-optistruct-memory options
你这个模型估计有点大,在xp下估计计算不了
回复 2# evanzpan 的帖子
哦好的
谢谢 和我的出现的问题一样啊.
ERROR # 7007 FROM SUBROUTINE check_mem
The run failed because automatic memory expansion has failed.
Currently allocated working storage is 1389 MB.
Automatic expansion failed to expand to 2497 MB.
The failed amount is the minimum required memory to complete the run.
Please verify whether the system has enough memory.If it has, then please
try this run with the fixed memory allocation to avoid a probable limitation
on the maximum locatable memory with the automatic memory allocation.
我的单元有六十几万.怎么解决这样的问题啊???? 别用默认的内存
自己指定一个
回复 5# mingmo 的帖子
指定一个也不行啊!请问上面二楼的把这个问题解决了吗? 是不是你的内存不够哦,它要1688MB的内存。
实在不行就不能用OPTISTRUCT算了,我有一个模型有77万个网格,用OPTISTRUCT根本算不了,有人说是因为OPTISTRUCT在32位的XP里只支持1。8G的内存。后来我改用nastrat算的,就可以成功计算了。 原来是这样我也碰到过这种问题 本帖最后由 bossile160 于 2009-9-10 13:11 编辑
我以前也碰到过这个问题
是模型太大了,简化一下吧
最好是简化三维网格,因为三维网格计算时占用的内存是二位网格的好几倍 本楼里感觉水平比较高,属于高端用户. 我也碰到了,我用的是64位Xp,400万个单元,节点数差不多,不知道为啥,哪位高手还是出来指点一下啥, 找个好点的计算机算啊 做CAE的要自己配一个很好的计算机啊。要不好多事情做不好啊,很郁闷的。 运行大问题时推荐linux 64位。Windows 本身有最大内存使用限制 问题出在这里
32位系统单机版OPTISTRUCT最多可以调用1G内存,即使windows xp在这里支持4G内存也不行 我刚开始可以算,但第二次就不能算了 这是什么问题啊/\各位大侠来指点一下了
页:
[1]