- 积分
- 0
- 注册时间
- 2009-11-4
- 仿真币
-
- 最后登录
- 1970-1-1
|
楼主 |
发表于 2014-1-13 23:26:54
|
显示全部楼层
来自 美国
本帖最后由 wrj001 于 2014-1-13 23:58 编辑
已找到:有三种方式:
1) Defining the kinematic hardening component by specifying the material parameters directly
Input File Usage: *PLASTIC, HARDENING=COMBINED, DATA TYPE=PARAMETERS, NUMBER BACKSTRESSES=n
Abaqus/CAE Usage: Property module: material editor: Mechanical Plasticity Plastic: Hardening: Combined, Data type: Parameters, Number of backstresses: n
2) Defining the kinematic hardening component by specifying half-cycle test data
Input File Usage: *PLASTIC, HARDENING=COMBINED, DATA TYPE=HALF CYCLE, NUMBER BACKSTRESSES=n
Abaqus/CAE Usage: Property module: material editor: Mechanical Plasticity Plastic: Hardening: Combined, Data type: Half Cycle, Number of backstresses: n
3) Defining the kinematic hardening component by specifying test data from a stabilized cycle
Input File Usage: *PLASTIC, HARDENING=COMBINED, DATA TYPE=STABILIZED, NUMBER BACKSTRESSES=n
Abaqus/CAE Usage: Property module: material editor: Mechanical Plasticity Plastic: Hardening: Combined, Data type: Stabilized, Number of backstresses: n
已找到,但关于背应力/静水应力的个数如何设还没找到? |
|