- 积分
- 1
- 注册时间
- 2009-7-7
- 仿真币
-
- 最后登录
- 1970-1-1
|
楼主 |
发表于 2012-1-14 20:56:38
|
显示全部楼层
来自 陕西西安
Plotting of user elements is not supported in Abaqus/CAE. However, if the user elements contain displacement degrees of freedom, they can be overlaid with standard elements; and model plots of these standard elements can be displayed, allowing you to see the shape of the user elements. If deformed mesh plots of the user elements are required, the material properties of the overlaying standard elements must be chosen so that the solution is not changed by including them. If this technique is used, nodes of the user element will be tied to nodes of the standard elements. Therefore, degrees of freedom 1, 2, and 3 in the user element must correspond to the displacement degrees of freedom at the nodes of the standard elements.
|
|