How to setup in solution Printout Controls

tianjian · 发表于 2012-12-12 09:30:27

Sorry for I cannot type in Chinese.
There are 3 steps in my model(static analysis of different loading case with the same boundary condition).
I want the result for all the three steps.

How to setup in solution Printout Controls? Thanks.

shifang157300 · 发表于 2012-12-12 15:21:07

本帖最后由 shifang157300 于 2012-12-12 15:23 编辑

"Every substep" is the appropriate option, so the results of every substep of each load step will be saved. Try to find out the difference between substep and load step.

tianjian · 发表于 2012-12-12 16:30:09

本帖最后由 tianjian 于 2012-12-12 17:00 编辑

Thanks for your help, shifang.
In my opinion, for a non-linear analysis, there usually are serveral substeps for a single load step becuase of iteration and covergece; for a linear elastic static(small deformation) analysis , there usually is only one substep in a singale load step.

账号		自动登录	找回密码
密码			注册

账号		自动登录	找回密码
密码			立即注册

[二次开发] How to setup in solution Printout Controls

本帖子中包含更多资源