整车装配出现点问题，求助下各位

timberwolf86

WARNING: The following input communicators were not assigned during assembly:
     testrig.cis_max_brake_value
     testrig.cis_downforce_coefficient
     testrig.cis_crankshaft_ratio
     testrig.cis_transmission_efficiency
     testrig.cis_drive_torque_bias_front
     zy_liang_front_sus.cil_ARB_pickup
     zy_liang_front_sus.cir_ARB_pickup
WARNING: The following input communicators did not match with unique output communicators:
     zy_powertrain.cil_tire_force
        matched with:  zy_liang_front_tire.col_tire_force
        also matches:  zy_liang_rear_tire.col_tire_force
     zy_powertrain.cir_tire_force
        matched with:  zy_liang_front_tire.cor_tire_force
        also matches:  zy_liang_rear_tire.cor_tire_force

JUVE熊

上面是有的通讯器没连上   
下面是有的输入通讯器匹配了不止一个输出通讯器      

下面的必须去模型里修改通讯器。。。     
我的是把下面的修改没以后，上面的没管，   能动了