- 积分
- 1
- 注册时间
- 2011-11-2
- 仿真币
-
- 最后登录
- 1970-1-1
|
想用Mohr-Coulomb塑性准则,但是老是出现这个错误,有人能说一下怎么解决这个问题么?
查了一下comso的错误data
错误编号:1150
http://www.comsol.com/support/knowledgebase/1150/
1. Problem Description
Why do I get the error Failed to compute elastoplastic strain variables when using plasticity/concrete/soil plasticity?
2. Solution
This happens because the elastoplastic element cannot evaluate a plastic step if the current stress state is outside of the yield surface. There are two situations where you may encounter this problem:
In the first load step
The elastoplastic element fails to evaluate the consistence conditions (due to either loads, displacements, initial stress/strains), and it fails to compute the first elastic-predictor step. That is, your initial state, e.g. assumed in-situ stresses in a geomechanical problem are outside the yield surface.
During postprocessing
When results are requested at other positions than the Gauss points, the elastoplastic element actually performs a stress computation. If the gradients of the elastoplastic strains are a large within an element this computation may fail. If this happens, use the Gauss point variables such as solid.sGpx instead of general variables like solid.sx.
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?注册
×
评分
-
1
查看全部评分
-
|