- 积分
- 0
- 注册时间
- 2006-6-1
- 仿真币
-
- 最后登录
- 1970-1-1
|
1.第一个模型分析过盈
2.第二个模型导入第一个分析的变形网格,以第一个分析结果作为初始状态,未添加任何约束和边界条件
作业检查未通过,出现下面图片问题(两个部件分离并有单元严重变形)
警告信息:
Material/behavior b540 has been redefined in the current analysis. Care must be taken to ensure that a consistent state can be maintained during the import procedure.
Material/behavior spfh590 has been redefined in the current analysis. Care must be taken to ensure that a consistent state can be maintained during the import procedure.
It is recommended that *section controls, hourglass=enhanced be used in the original analysis for consistent treatment of hourglass forces in both original as well as import analyses
It is recommended that *section controls, hourglass=enhanced be used in the original analysis for consistent treatment of hourglass forces in both original as well as import analyses
错误信息为:
The volume of 41 elements is zero, small, or negative. Check coordinates or node numbering, or modify the mesh seed. In the case of a tetrahedron this error may indicate that all nodes are located very nearly in a plane. The elements have been identified in element set ErrElemVolSmallNegZero
请教各位这该怎么解决
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?注册
×
|