- 积分
- 12
- 注册时间
- 2005-1-8
- 仿真币
-
- 最后登录
- 1970-1-1
|
发表于 2011-8-12 13:39:58
|
显示全部楼层
来自 广东惠州
本帖最后由 arrow_hwang 于 2011-8-12 13:47 编辑
Reservoir : a Reservoir type material is a domain where the free surface will always be perpendicular to the gravity. This allows to simplify the free surface computation and it is especially useful in the case of tundish modeling. The "RESERVOIR" domains should have an "EQUIV" interface with the other CASTING materials.
Please note that if there is more than one RESERVOIR domain, they should all touch each other and they should be all full at the beginning. Otherwise, problems may be encountered.
If one want to empty the reservoir, no special BC should be specified. If one would like to keep the reservoir full, a pressure BC should be set at the surface of the reservoir.
Finally the user has to specify which domains are empty at the beginning of the calculation (for mold filling calculations). One should make a left click on the "No" to turn it to "Yes" (which means that Yes the domain is empty). On additional click returns to No. Of course, more than one domain may be empty (if the casting is made out of several mesh domains).
这个是帮助原文,稍后翻译。 |
|