subarray error?!?

gubarrani

i have met with this error. What does it mean? Where do i have to look at?

%F-DS001904-IARGET,,,                                                         
        Internal subarray starts at illegal position                           
        Name of internal subarray is MESH INIT                                 
        ID of internal subarray is 219                                          
        Position is 61                                                         
        Called by P2XXTXIX_SET_EXTRA_POINTS                                    
        Follow-up message. Check previous or following messages.               
NO MORE MESSAGES OF THIS KIND WILL BE WRITTEN

yfs_000

It is hard to solve your problem if you only provide some error messages here.

gubarrani

you can find the patran database files, and datran dat, bdf's in the link.

   http://rapidshare.de/files/41118059/Desktop.rar.html

yfs_000

I got it. Let me try...

The error was shown as follow when I run the model.


                                                                                
%C-DS000104-ARDEF,,,                                                           
        Cannot create dynamic subarray EUL EL FLOAT VARS.                       
        Dynamic memory allocation failed. There is not enough                  
        memory available. This can occur when your computer is                  
        heavily loaded with other applications.

You operating system is xp 64 bit and mine is 32  bit. Maybe the error is related to the computers.

[ 本帖最后由 yfs_000 于 2008-12-16 23:15 编辑 ]

gubarrani

ok i see. but what is your suggestion for me? In my error message it mentions about "MESH INIT" what does it mean? Where shoul i look at? Is it about the mesh of the model?

gubarrani

I mean where do i look at first? Should i look the model or the dytran code? Where is the errror?

yfs_000

Are you using the MESH card to generate an Euler mesh? If so, you might have the parameters set to create such a fine Euler mesh that the number of generated elements is overflowing Dytran's limits.

gubarrani

yes, i use mesh card.
MESH,450,ADAPT,20.,20.,20.,,,,+
you mean i should increase the number of the 20 to 30,40,..? Or redraw smaller euler domains? or both of them may be?

yfs_000

I think you can solve this problem though adjusting the euler elements number . Let me know your doing.

gubarrani

i tried but could not succeeded. There should be something we do not know or miss. Error has to be about euler elements but i do not know how to solve it. I will think about it...