- 积分
- 9
- 注册时间
- 2002-7-11
- 仿真币
-
- 最后登录
- 1970-1-1
|
I run a model in my C: disk using ABAQUS ,It had about 17.5GB
but only about 4 GB free.
The model was running till 5th step out of 45 steps
and then there was an error due to lack of space of
the disk.
I copied ABAQUS and my inp.file to D: with 15 GB free
space, and then when I wanted to run it there was an
error in the very begining of the process saying that
the analysis ended with error and that I should check
disk capacity to see if I have enough capacity!!!While
I had less capacity in C: and there was no messages!
I have already increased the pre and standard memory
in env.file which I don't think is important in this
case.
Could you help me with that?How can I get enough space
for the analysis? |
|