【求助】Pro/e的造型如何传到Patran里面？？

gyz_cloud

各位大虾，小弟刚刚开始接触Patran，我从Patran里直接import在
Pro/e里做好的零件时，显示错误信息
The Pro/Toolkit foreign program "p3_ProENGINEER" supplied by MSC.Software Corporation was either not executed by Pro/ENGINEER or did not execute to completion. Verify that your workstation has been registered to run Pro/ENGINEER if importing a Part (PRT) or an Assembly (ASM).  Also verify that the file input for import exists.
这两个软件的版本分别为 2000i2 和 2001r2a
我的Patran是完全安装的
望各位大虾给予小弟一些指导！Thanks！

679lihuijun

我也有这样的问题，谢谢兄弟

fz02wang

试试就知道了呗，就指着吃现成的啊！

刘半饱

转成IGS就好啦，2楼说的对。