求助：打开truck最后提示mount的communicator没装配好，怎么办

whhit

我用2003打开shared_truck模型，最后匹配communicator的时候提示
This template is now compatible with ADAMS/Car v2003.
Assembling subsystems...
Assigning communicators...
WARNING: The following input communicators were not assigned during assembly:
     testrig.cis_steering_rack_joint
     testrig.cis_max_brake_value
     testrig.cil_rear_suspension_mount (attached to ground)
     testrig.cir_rear_suspension_mount (attached to ground)
WARNING: The following input communicators did not match with unique output communicators:
     testrig.cis_diff_ratio
        matched with:  msc_truck_drive_axle_front.cos_final_drive
        also matches:  msc_truck_drive_axle_rear.cos_final_drive
     msc_truck_powertrain.cis_halfshaft_omega_left
        matched with:  msc_truck_drive_axle_front.cos_halfshaft_omega_left
        also matches:  msc_truck_drive_axle_rear.cos_halfshaft_omega_left
     msc_truck_powertrain.cis_halfshaft_omega_right
        matched with:  msc_truck_drive_axle_front.cos_halfshaft_omega_right
        also matches:  msc_truck_drive_axle_rear.cos_halfshaft_omega_right
     msc_truck_powertrain.cis_final_drive
        matched with:  msc_truck_drive_axle_front.cos_final_drive
        also matches:  msc_truck_drive_axle_rear.cos_final_drive
Assignment of communicators completed.
Assembly of subsystems completed.
Full vehicle assembly ready.
里面提示rear_suspension的communicator都没匹配好，这是怎么回事啊？难道car不认得rear_suspension?
希望高手帮忙分析一下原因，非常感谢！在线等

[ 本帖最后由 whhit 于 2007-12-25 15:23 编辑 ]

liuxiaoming

你建立的communicator必须对应unique output/input communicators,是一一对应关系!!

peakpine

遇到相似的问题
很难啊