- 积分
- 0
- 注册时间
- 2009-4-24
- 仿真币
-
- 最后登录
- 1970-1-1
|
发表于 2009-5-14 17:41:26
|
显示全部楼层
来自 河南郑州
24# john152
请问一个问题,我做李军老师小军时,仿真出现了如下问题,我看贴了,是个共性问题,你能不能给解答一下呀,谢谢呀
WARNING: The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING: The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING: The corrector has not converged after 6 attempts. No. of iterations = 20.
ERROR: The simulation stopped at time = 0.50694 . ADAMS cannot solve
the equations of motion.
The greatest error in an equation is 3.45636E-03 in the
equation for GFORCE model_1.l_b.force .
The greatest change in a variable is 2.53717E-14 in the
variable for PART model_1.center_link .
Try the following in this order:
1. Use the MAXIT argument on the EQUILIBRIUM, IC, KINEMATICS,
or INTEGRATOR command to increase the maximum number of
iterations.
2. Temporarily change the value of the PATTERN argument on the
EQUILIBRIUM, IC, KINEMATICS, or INTEGRATOR command to
PATTERN = T.
3. Temporarily increase the value of the ERROR argument on the
EQUILIBRIUM, IC, KINEMATICS, or INTEGRATOR command at
time = 0.50694 .
4. If one or more forces change rapidly or sharply near
time = 0.50694, modify the force or forces.
ERROR: Simulation failure detected |
|