仿真报错，求助

cxj0927

刚性模型已经调好，想细化一下，把一个PART件用AUTOFLEX做成柔性体，这就需要这个PART件只有一个几何体。于是，我就用布尔运算，把原本很多个几何体构成的PART连成一个，连好以后，就报错了。。。。
WARNING:    The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING:    ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
   NOTE:  The set of redundant constraints has changed at time = 0.0.
   ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
  
WARNING:    The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING:    ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
   NOTE:  The set of redundant constraints has changed at time = 0.0.
   ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
  
WARNING:    The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING:    The corrector has not converged after 6 attempts. No. of iterations = 10.
WARNING:    The corrector has not converged after 6 attempts. No. of iterations = 20.
ERROR:      The simulation stopped at time = 2.65625E-02 .
  
   ADAMS cannot solve the equations of motion because the Jacobian matrix
   is ill-conditioned.
  
   The ratio of the smallest to the largest pivot elements is 1.98405E-23 .
   You must increase this ratio before ADAMS can solve the equations
   within the desired accuracy.
  
   The smallest pivot is 5.17881E-16 which is related to the sensitivity
   of the equation for PART counter_strike_wall.qi_shen_jia with respect to the variable JOINT counter_strike_wall.JOINT_1 .
  
   The largest pivot is 2.61022E+07 which is related to the sensitivity of
   the equation for FLEX_BODY counter_strike_wall.Flexible_Body_xinzhou3 with respect to the variable FLEX_BODY counter_strike_wall.Flexible_Body_xinzhou3 .
  
   Try the following in this order:
       1.  Remove any HMAX arguments from the INTEGRATOR command and
           issue a new SIMULATE command with a smaller value for the
           STEPS argument.
       2.  Temporarily increase the value of the ERROR argument on the
           INTEGRATOR command at time = 2.65625E-02 .
       3.  Rescale the model using larger units.
  
ERROR:   Simulation failure detected
哪位高手能指点一下

neso770

我和你一样的困惑 怎么高手不现身呢