not all the nodes that have been adjusted were printed

springhall · 发表于 2011-4-25 09:54:40

本帖最后由 zsq-w 于 2011-4-25 09:57 编辑

1，For contact pair (assembly_conrete-1_condown-assembly_down-1_downup), not all the nodes that have been adjusted were printed. Specify *preprint,contact=yes for complete printout
2，For *tie pair (assembly_up-1_upuper-assembly_mat-1_matdown), adjusted nodes with very small adjustments were not printed. Specify *preprint,model=yes for complete printout.
3，46 nodes have been adjusted more than once. The subsequent adjustments may cause these nodes not to lie on their master surface. The nodes have been identified in node set WarnNodeAdjust.
怎么解决
还有我用的是cae建立的模型，是不是有些地方需要在inp文件中修改啊
谢谢帮助

fangzhenalo · 发表于 2011-4-25 10:23:42

你这个是waining 信息还是什么？

一般情况下警告信息可以忽略。。。

如果用tie约束的是四面体网格，最好把tie约束中的adjust选项关掉。

springhall · 发表于 2011-4-25 10:51:44

是warn,谢谢你那第一个警告怎么处理

JingheSu · 发表于 2011-4-25 14:00:43

那个是对你的求解没有影响的

账号		自动登录	找回密码
密码			注册

账号		自动登录	找回密码
密码			立即注册

[警告错误信息] not all the nodes that have been adjusted were printed

相关帖子

评分